Chassis Intrusion Connector; Figure 3-4: Battery Connector Location; Figure 3-5: Chassis Intrusion Connector Location; Table 3-5: Battery Connector Pinouts - IEI Technology AESQ170-969 User Manual

regulations.
CN Label: BAT1
CN Type: 2-pin wafer, p=1.25 mm
CN Location: See Figure 3-4
CN Pinouts: See Table 3-5
This is connected to the system battery. The battery provides power to the
system clock to retain the time when power is turned off.

Figure 3-4: Battery Connector Location

Pin
1 VBATT
2 GND
3.2.4

Chassis Intrusion Connector

CN Label: CHASSIS1
CN Type: 2-pin header, p=2.54 mm
CN Location: See Figure 3-5
CN Pinouts: See Table 3-6
The chassis intrusion connector is for a chassis intrusion detection sensor or
switch that detects if a chassis component is removed or replaced.

Figure 3-5: Chassis Intrusion Connector Location

Description

Table 3-5: Battery Connector Pinouts

Chapter 3
28
Connectors