Intel ® Amt Setup Procedure; Figure 4-22: Update Process Is Complete - IEI Technology AESQ170-969 User Manual

Table of Contents

Step 9:

Now the user can proceed with the Windows 7 installation using the

updated installer.

4.12 Intel

AMT Setup Procedure

The AESQ170-969 is featured with the Intel

(AMT). To enable the Intel

Step 1:

Make sure at least one of the memory sockets is installed with a

DDR4 DIMM.

Step 2:

Connect an Ethernet cable to the RJ-45 connector labeled LAN1.

Step 3:

The AMI BIOS options regarding the Intel

enabled,

Step 4:

Properly install the Intel

from the iAMT Driver & Utility directory in the driver CD.

Step 5:

Configure the Intel

To get into the Intel

beep during boot-up process. Enter the Intel

as it requires (the Intel® default password is admin).

NOTE:

To change the password, enter a new password following the strong

password rule (containing at least one upper case letter, one lower

AMT function, follow the steps below.

Management Engine Components drivers

Management Engine BIOS extension (MEBx).

MEBx settings, press <Ctrl+P> after a single

Chapter 4

Active Management Technology

ME or Intel

current ME password

Installation

AMT must be

Table of Contents