Dimm Installation; Figure 4-6: Dimm Installation - IEI Technology AESQ170-969 User Manual

Step 3: Mount the cooling kit. Gently place the cooling kit on top of the
CPU. Make sure the four threaded screws on the corners of the cooling kit
properly pass through the holes of the cooling kit bracket.
Step 4: Tighten the screws. Use a screwdriver to tighten the four screws.
In a diagonal pattern, tighten each screw a few turns then move to the next
one, until they are all secured. Do not overtighten the screws.
Step 5: Connect the fan cable. Connect the cooling kit fan cable to the
CPU fan connector on the AESQ170-969. Carefully route the cable and avoid
heat generating chips and fan blades.

4.5 DIMM Installation

To install a DIMM, please follow the steps below and refer to Figure 4-6.
Step 1: Open the DIMM socket handles. Open the two handles outwards
as far as they can. See Figure 4-6.
Step 2: Align the DIMM with the socket. Align the DIMM so the notch on
the memory lines up with the notch on the memory socket. See Figure 4-6.
Step 3: Insert the DIMM. Once aligned, press down until the DIMM is

Figure 4-6: DIMM Installation

57
Chapter 4 Installation