Checking The Software Version; Show Version Command - Cisco 12406 Installation And Configuration Manual

Chapter 3 Installing the Router
Note

Checking the Software Version

show version Command

OL-11497-03
You might have to establish additional configuration parameters for the installed
ATM line cards if you want to use all their capabilities. For example, additional
steps are required to configure permanent virtual circuits (PVCs).
After you have manually configured the network interface parameters using the
setup command utility or the setup command, your RP and line card interfaces
are available for limited use. To modify the currently saved configuration
information, enter the setup command at the privileged EXEC mode prompt
( ) at any time to start another System Configuration Dialog session.
Router#
To perform more complex configuration tasks, enter the configure terminal
command at the privileged EXEC mode prompt (
configuration mode [
Router(config)#
To determine the current version of the Cisco IOS software running on your
router, enter the show version command at the user EXEC prompt. The Cisco IOS
software version number is displayed, as well as other information, including the
hardware installed in the system, the names and sources of system image files, and
the contents of the software configuration register. The show version command
also identifies the type of router.
The example in the show version Command
typical results from the show version command. Depending on the image version
of the Cisco IOS software running on your router and the way it is equipped, the
results of your show version command might be different.
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) GS Software (GSR-P-M)
12.0(20020120:204554)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Sat 20-Aug-01 18:34
Image text-base: 0x60010950, data-base: 0x61C00000
ROM: System Bootstrap, Version 11.2(17)GS2, [name 180] EARLY
DEPLOYMENT RELEA)
Cisco 12006 and Cisco 12406 Router Installation and Configuration Guide
Configuration Changes
) to invoke the global
Router#
].
section that follows below shows
3-61