Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 416

System board and components
▶ Press the locking spring into direction of the arrow (1), so that the CMOS
battery jumps out of its socket.
▶ Remove the CMOS battery (2).
CAUTION
Sharp tools such as screw drivers might damage system board
components in case of slipping.
▶
If the CMOS battery cannot be ejected without the help of a tool,
it is recommended to use a tooth pick.
▶ Insert a new CMOS battery of the same type into the socket (3) and (4).
Concluding steps
▶ Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
▶ If applicable, install the SAS expander board holder, see
expander board holder " on page
▶ Install the system fan module, see
page 85.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ BIOS settings are automatically reloaded. Time and date must be set
manually, see "Verifying the system time settings" on page
You must manually change the BIOS settings according to the note
on your current BIOS settings, see
on page
416
66.
415.
Upgrade and Maintenance Manual
271.
"Installing the system fan module" on
79.
81.
"Note on BIOS settings recovery"
"Installing the SAS
116.
TX1330 M4