Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 10

Content
4.10 Handling the anti-tilt bracket
4.10.1 Installing the anti-tilt bracket
4.10.2 Removing the anti-tilt bracket
5 Basic software procedures
5.1 Validation
5.2 Starting the maintenance task
5.2.1 Suspending BitLocker functionality
5.2.2 Disabling the boot watchdog
5.2.3 Removing backup and optical disk media
5.2.4 Verifying and configuring the backup software solution
5.2.5 Switching on the ID indicator
5.3 Completing the maintenance task
5.3.1 Updating or recovering the BIOS and iRMC S5
5.3.2 Verifying system information backup or restore
5.3.3 Updating expansion card firmware
5.3.4 Enabling Option ROM scan
5.3.5 Reconfiguring the backup software solution
5.3.6 Resetting the boot retry counter
5.3.7 Resetting the error status after replacing memory modules or
CPUs
5.3.7.1 Resetting the error status after replacing memory modules
5.3.7.2 Resetting the error status after replacing CPUs
5.3.8 Enabling the boot watchdog
5.3.9 Enabling replaced components in the BIOS
5.3.10 Verifying the memory mode
5.3.11 Verifying the system time settings
5.3.12 Viewing and clearing the System Event Log (SEL)
5.3.13 Updating the NIC configuration file in a Linux and VMware
environment
5.3.14 Resuming BitLocker functionality
5.3.15 Performing a RAID array rebuild
5.3.16 Looking for MAC/WWN/GUID and SAS addresses
5.3.16.1 Basic information
5.3.16.2 Looking for the MAC address of a LAN controller
5.3.16.3 Looking for the WWN address of a fibre channel controller
Upgrade and Maintenance Manual
97
97
98
99
99
99
99
100
102
102
102
103
103
105
106
107
108
108
110
110
112
114
115
116
116
117
120
121
122
123
123
123
124
TX1330 M4