Figure 309: Securing the accessible drive cage (B)
▶ Carefully turn the server upside down.
At least two people are needed to turn over a fully equipped server.
Remove HDDs and hot-plug PSUs in order to facilitate the task.
▶ Secure the accessible drive cage with the two screws (see circles) to the
bottom side of the server.
Note the correct screw positions: The screw hole on the right that has
been used in the floorstand model configuration remains empty.
▶ Reinstall the front panel (rotated by 90 degrees), see
front panel module" on page
▶ Reinstall all accessible drives into their original bays (rotated by
90 degrees), see
▶ Reinstall all accessible drive filler covers and front covers, see
accessible drive covers" on page
▶ If applicable, install an HDD extension box, see
page
241.
TX1330 M4
Converting a floorstand model to a rack model
409.
"Installing an accessible drive" on page
96.
Upgrade and Maintenance Manual
"Installing the new
366.
"Installing
"HDD extension box" on
469