▶ Remove the PSU and install the dummy cover carefully.
▶ Mount the complete assembly (CMA stopper, the crossbar and the CMA)
again into the rail.
▶ If applicable, close the CMA of the server below.
Preliminary steps
▶ Only when replacing a PSU in a non-redundant configuration:
down the server" on page
Removing a hot-plug PSU
▶ Remove the power cord from the dedicated PSU, see
power cord" on page
Figure 73: Removing the PSU
▶ Push the handle of the PSU halfway upward in the direction of the arrow (1).
▶ Press in on the green locking latch (2).
TX1330 M4
47.
48.
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Shutting
"Disconnecting the
151