Fujitsu PRIMERGY TX1330 M4 Upgrade And Maintenance Manual page 448

System board and components
Replacing the microSD card
▶ Remove the Dual microSD 64GB Enterprise, see
microSD 64GB Enterprise" on page
▶ Remove the defective microSD card from the Dual microSD 64GB
Enterprise.
Proceed as described in the following:
▶ To eject the defective microSD card, gently push it in and then let go, see
Figure 294.
▶ Pull the microSD card straight out of its slot.
CAUTION
(not valid for Europe, Middle East, India and Africa)
The microSD card contains customer information.
▶
After removing the microSD card, hand the card over to the
customer.
▶
If the customer requests disposal of the defective microSD
card, proceed as follows: Using a pair of side-cutting pliers,
cut the microSD card in half.
▶ Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
▶ With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see
▶ Install the Dual microSD 64GB Enterprise, see
64GB Enterprise" on page
Concluding steps
▶ Install the system fan module, see
page 85.
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
448
444.
441.
"Installing the system fan module" on
66.
79.
81.
Upgrade and Maintenance Manual
"Removing the Dual
Figure 295).
"Installing the Dual microSD
TX1330 M4