Changing The Rear Brake Disc; Checking The Chain Tension - Husqvarna FC 250 2017 Repair Manual

14 WHEELS
14.8.3
14.8.4
Warning
wheel bearings wear more quickly. Some components may break if overloaded.
rear wheel locks or the engine will be damaged.
-
-
124

Changing the rear brake disc

Info
If the brake discs are changed, the brake linings must also be changed.

Checking the chain tension

Incorrect chain tension damages components and results in accidents.
Danger of accidents
If the chain is tensioned too much, the chain, engine sprocket, rear sprocket, transmission and rear
If the chain is too loose, the chain may fall off the engine sprocket or the rear sprocket. As a result, the
Check the chain tension regularly.
Set the chain tension in accordance with the specification.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the rear wheel. (8
Main work
-
O.
Remove screws Remove the brake disc.
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws
Guideline
Screw, rear M6
brake disc
Finishing work
-
Install the rear wheel. (8
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
Main work
-
Pull the chain at the end of the chain sliding piece upward to
measure chain tension G.
Info
Lower chain section
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
Chain tension
I
If the chain tension does not meet the specification:
-
Adjust the chain tension.
Finishing work
-
Remove the motorcycle from the lift stand.
(8 p. 12)
p. 122)
O.
14 Nm (10.3 lbf ft)
Loctite
p. 123)
(8 p. 12)
(0 p. 12)
O must be taut.
55 ... 58 mm (2.17 ...
1
2.28 in)
(8 p. 125)
p. 12)
(8
®
243
™
...