Table of Contents
Advertisement
13
BRAKE SYSTEM
13.13
Checking the rear brake linings
Warning
Danger of accidents Worn-out brake linings reduce the braking effect.
–
Ensure that worn-out brake linings are replaced immediately. (Your authorized KTM workshop will be glad to help.)
13.14
Changing the rear brake linings
Warning
Danger of accidents Incorrect maintenance will cause the brake system to fail.
–
Ensure that service work and repairs are performed professionally. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid causes skin irritation.
–
Keep brake fluid out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Do not allow brake fluid to come into contact with the skin, the eyes or clothing.
–
Consult a doctor immediately if brake fluid has been swallowed.
–
Rinse the affected area with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water immediately and consult a doctor if brake fluid comes into contact with the eyes.
–
If brake fluid spills on to your clothing, change the clothing.
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service schedule. (Your autho-
rized KTM workshop will be glad to help.)
Warning
Danger of accidents Brake linings which have not been approved alter the braking efficiency.
Not all brake linings are tested and approved for KTM motorcycles. The structure and friction coefficient of the brake linings,
and thus their brake power, may vary greatly from that of original brake linings.
If brake linings are used that differ from the original equipment, compliance with the original homologation is not guaranteed.
In this case, the vehicle no longer corresponds to its condition at delivery and the warranty shall be void.
–
Only use brake linings approved and recommended by KTM.
Preparatory work
–
Check the rear brake linings. (
Main work
–
Stand the vehicle upright.
–
Remove screw cap
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the membrane and the O-ring.
Info
E00348-10
Clean up overflowed or spilled brake fluid immediately with water.
–
Check the brake linings for minimum thickness
Minimum thickness
»
If the minimum thickness is less than specified:
–
Change the rear brake linings.
–
Check the brake linings for damage and cracking.
»
If damage or cracking is visible:
–
Change the rear brake linings.
E00349-10
p. 83)
with membrane
and the O-ring.
.
p. 141)
≥ 1 mm (≥ 0.04 in)
(
p. 83)
(
p. 83)
.
83
Advertisement
Table of Contents
