Changing The Rear Brake Disc - Husqvarna FC 350 2016 Repair Manual

14 WHEELS
14.7.3
118

Changing the rear brake disc

Info
If the brake discs are changed, the brake linings must also be changed.
-
Position chain adjuster (5) . Mount nut
it yet.
-
Make sure that chain adjusters (5) are fitted correctly on
0-
adjusting screws
-
Check the chain tension.
C,.
-
Tighten nut
Guideline
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary ratios
with the same chain length.
Chain adjusters (5) can be turned by 180
-
Operate the foot brake lever repeatedly until the brake lin­
ings are in contact with the brake disc and there is a pressure
point.
Finishing work
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the rear wheel. (a
Main work
O.
-
Remove screws Remove the brake disc.
-
Clean the contact surface of the brake disc.
-
Position the new brake disc with the label facing outward.
-
Mount and tighten screws
Guideline
M6
Screw, rear
brake disc
Finishing work
-
Install the rear wheel. (ll!:!l
-
Remove the motorcycle from the lift stand.
C,,
but do not tighten
(� p. 119)
M25x1.5 80 Nm (59 lbf ft)
°
.
(!!ll p. 12)
(� p. 12)
p. 116)
O.
14 Nm (10.3 lbf ft)
Loctite
p. 117)
(� p. 12)
®
243
™