Displaying And Setting The Fastboot Mode - HP Visualize J2240 Service Handbook

Displaying and Setting the Fastboot Mode

Access fastboot from the configuration menu.
When fastboot is enabled (set to on), your workstation does a quick check of the
memory and skips I/O interface testing during its power–on self tests. This enables
your workstation to complete its boot process quicker. The default factory setting is
for fastboot to be enabled (on).
The fastboot mode allows your workstation to boot quickly by performing a less
extensive check of the system's memory.
When fastboot is disabled (set to off), more extensive memory testing and I/O inter-
face testing is performed during the self tests, causing the boot process to take longer.
If you are experiencing difficulty in booting your workstation, set fastboot to off and
reboot the system. The more extensive testing may reveal the error condition.
To display the status of fastboot, type the following at the configuration menu
prompt:
fastboot Enter
To disable fastboot, type the following at the prompt:
fastboot off Enter
To enable fastboot, type the following at the prompt:
fastboot on Enter
10–18 Boot Console