Front Bezel; Opening The System Unit - HP Visualize J2240 Service Handbook

Front Bezel

This section describes how to remove the J Class front bezel or cover of the system
unit.
CAUTION: Do not attempt to operate the workstation with the
front cover removed. The cover is needed for proper
air flow for system cooling.
1. Attach the static-grounding wrist strap by following the instructions on the
package. Attach the the sticky end of the wrist strap to bare metal of the system
unit.
2. Release the front cover by pushing in the two locking tabs at the front of the sys-
tem unit as shown in Figure 5–9.
Figure 5–9. Opening the System Unit
3. Swing the panel down and pull up slightly so the two guide pins on the bottom
clear their guides and lay the front cover down.
Reverse this process to replace the J Class front cover.
Be sure top latches snap completely into position.
5–16 Field Replaceable Units