Configure And Display Lan Settings (J2240 Only) - HP Visualize J2240 Service Handbook

Displaying the LAN Station Address
It is sometimes necessary to supply a LAN station address of your workstation to
other users. For example, if your workstation is to become a member of a cluster, the
cluster administrator needs to know your LAN station address in order to add your
workstation to the cluster.
A LAN station address of your workstation is the label that uniquely identifies the
LAN connection for your workstation at the link level (the hardware level).
To display your workstation's LAN station addresses, type the following at the in-
formation menu prompt:
lanaddress
Enter
The LAN station address is displayed as a twelve–digit number in hexadecimal nota-
tion, similar to the following:
LAN Station Addresses:
The address is for the system's built–in LAN.

Configure and Display LAN Settings (J2240 Only)

The LanConfig command configures and displays the current LAN settings. The
hardware system supports 10Base–T, 100Base–T and AUI standards.
To automatically select the network speed (100 Mbits/sec) and data transfer operation
(full or half duplex), operating in compliance with IEEE 802.3u, (this is the default
and recommended setting) type the following at the prompt:
Configuration Menu: Enter command > LanConfig AUTO
To select 10 Mbits/sec network speed and half duplex mode, type the following at the
prompt:
Configuration Menu: Enter command > LanConfig 10/Half_dx
To select 10 Mbits/sec network speed and full duplex mode, type the following at the
prompt:
Configuration Menu: Enter command > LanConfig 10/Full_dx
To select 100 Mbits/sec network speed and half duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 100/Half_dx
To select 100 Mbits/sec network speed and full duplex mode, type the following at
the prompt:
Configuration Menu: Enter command > LanConfig 100/Full_dx
080009–789abc
Enter
Enter
Enter
Enter
Enter
Boot Console 10–19