Displaying And Setting Fastboot Mode - HP Visualize j6000 Supplementary Manual

Displaying and Setting Fastboot Mode

When fastboot is enabled (set to on), the workstation does a quick check of the memory
and skips some processor self tests during its power-on self tests. This enables the
workstation to complete its boot process quicker. The default factory setting is for
fastboot to be enabled (set to on).
When fastboot is disabled (set to off), more extensive memory and processor testing is
performed during the selftests, causing the boot process to take longer.
If you are experiencing difficulty in booting the workstation, set fastboot to off and
reboot the system. The more extensive testing may reveal the error condition.
To display the status of fastboot, type the following:
Configuration Menu: Enter command > fastboot [Enter]
To disable fastboot, type the following:
Configuration Menu: Enter command > fastboot off [Enter]
To enable fastboot, type the following:
Configuration Menu: Enter command > fastboot on [Enter]
Chapter 5
Boot Console Handler
Displaying and Setting Fastboot Mode
125