Displaying And Setting The Monitor Type; The Monitor Command - HP Visualize J2240 Service Handbook

Displaying and Setting the Monitor Type

Your system ships from the factory preset to use a monitor with a specific resolution
and frequency. If you replace your workstation's monitor with a different type of
monitor, you must reconfigure your workstation to support the new monitor.

The Monitor Command

The monitor command lets you change your workstation's graphics configuration.
This command is available in both the Information and Configuration Menus of the
boot console interface, however when you use it in the Information Menu, monitor
only displays the current graphics and console information. You must use monitor in
the Configuration Menu to set a monitor type.
The correct usage for this command is:
monitor <graphics_path>
where valid graphics_path parameters are:
graphics0 Graphics device in slot0. If using a Dual Graphics Card, this is the
port to the right on the card when facing the back of the workstation.
graphics1 Graphics device in slot1. If using a Dual Graphics Card, this is the
port to the right on the card when facing the back of the workstation.
graphics2 Graphics device in slot2. If there is a Dual Graphics Card in slot1,
this is the port to the left on the card when facing the back of the
workstation.
graphics3 This is a logical slot, and can only be reached by using the left port
of a Dual Graphics Card in physical slot0.
NOTICE: We do not recommend using a Dual Graphics Card in
slot2, other than the CRX/HCRX. If using the dual
graphics card, it must be the only card in the system
and be physically located in slot0
9–10 Boot Console