HP Visualize J2240 Service Handbook page 212

To display the current setting for a particular system path, follow the directions in
"Accessing the Boot Console Interface" earlier in this appendix, and then type the
following at the prompt:
Main Menu: Enter command >
where path_type is one of the path types listed in .
For example, to get the path to the primary boot device, follow the directions in
"Accessing the Boot Console Interface" earlier in this chapter, and then type the fol-
lowing at the prompt:
Main Menu: Enter command >
To set a system path to a new value, follow the directions in "Accessing the Boot
Console Interface" earlier in this chapter, and then type the following at the
prompt:
Main Menu: Enter command >
where path_type is one of the path types listed in Table 10– 1 and path is the specifi-
cation of the path in Mnemonic Style Notation (as described in Table 10– 2). For
example, to set the primary boot path to a scsi disk with an ID of 6.0, follow the
directions in "Accessing the Boot Console Interface" earlier in this appendix, and
then type the following at the prompt:
Main Menu: Enter command >
10–10 Boot Console
path path_type
Enter
path primary
path path_type path
path pri sescsi.6.0 Enter