Memory Dimm Installation - HP Visualize J2240 Service Handbook

Memory DIMM Installation

Before installing memory DIMMs, open the system unit and remove the CPU assem-
bly.
Refer to Chapter 3 for information about memory DIMM configurations.
1. To install a new memory DIMM, open the ejector tabs and line the DIMM up
with the guides as shown in Figure 5–15, making sure to put the notched end to-
ward the white ejector handle.
Notched end
Close the ejector tabs.
Push the DIMM firmly and evenly
into the connector to be sure it
is properly seated.
Figure 5–15. Installing Memory DIMMs
2. Close the ejector tabs.
3. Press firmly and evenly on the DIMM to ensure that it is fully seated.
4. To verify that this installation was successful, display the current memory in-
formation using the Boot Console Interface. For more information on the Boot
Console Interface, see Chapter 9 of this handbook. If only a faulty DIMM is re-
placed, use the pdt clear command in the service menu of the Boot Console In-
terface. Answer y to the prompt Continue? (Y/N).
Press down on ejector tabs to open them and place
the DIMM in the connector so that the fingure is on
the edge of the DIMM just touch the connector.
Press DIMM down slightly
Ejector tabs pop partly back up.
Push ejector tabs until they lock
in place.
Close the ejector tabs.
Field Replaceable Units 5–21