Table 64 Ethernet/Ip Module Led States; Table 65 Ethernet Status; Table 66 Led States - Ethernet - WAGO 765-1503/100-000 Product Manual

Diagnostics
LED
LED State
Flashing
(1 Hz)
Rapid flashing
green/red/green
Flashing sequence
red/green/off
LED
LNK
(Link)
ACT
(Activity)
LED State
Flickering
(load-dependent)
98 Product manual | Version: 2.0.0
16DO FLD EI DC 24V 2.0A
Color State
Green/red/off Rapid flashing:
green/red/off
Red/green/off Flashing sequence:
red/green/off
Red Flashing (1 Hz)
Red On
Off Off
Definition
The LED switches on and off in phases at a frequency of about 1 Hz:
on for 500 ms and then off for 500 ms.
The MS LED or NS LED lights up green for 250 ms, then red for 250 ms, then green
again (until the test is completed).
The MS LED and NS LED both light up red for 500 ms, then light up green for 500 ms,
then go out for 500 ms. The flashing sequence repeats at least six times.
Color State
LED green
Green On
Off Off
LED yellow
Yellow Flickering (load-de-
pendent)
Off Off
Definition
The LED indicates high ETHERNET activity by switching on and off at a frequency of
10 Hz:
"On" for 50 ms and then "Off" for 50 ms.
The LED indicates low ETHERNET activity by switching on and off at irregular intervals.
765-1503/100-000
Description
Self test: The module runs through a self
test after it is switched on. See the descrip-
tion of the "MS" LED and the description of
the "Self test" status.
Flashing sequence: The flashing se-
quence identifies the adapter visually. The
scanner can start the flashing sequence in
identity object 1 of the adapter. The MS
LED and NS LED go through the flashing
sequence simultaneously.
Connection timeout:An IP address is con-
figured, and, for an Exclusive Owner con-
nection for which this module is the destina-
tion, the time limit has been exceeded. The
NS LED is not permanently reset to green
until all Exclusive Owner connections
whose time limits were exceeded are
reestablished.
Duplicate IP: The module has detected
that its IP address is already being used.
Switched off, no IP address: The module
has no IP address or is switched off.
Table 64: EtherNet/IP Module LED States
Table 65: Ethernet Status
Description
The module is connected to the Ethernet.
The module is not connected to the Ether-
net.
The module is sending/receiving Ethernet
frames.
The module is not sending/receiving Ether-
net frames.
Table 66: LED States – Ethernet