Resetsetting The Module To The Factory Settings; Table 42 Options For Resetting The Module To The Factory Settings - WAGO 765-1503/100-000 Product Manual

Commissioning
The firmware update procedure is as follows:
1. The firmware from the FWUPDATE.ZIP firmware container file is stored in the mod-
ule's flash memory.
2. An internal reset is triggered.
3. Then the device maintenance firmware starts; this edits the firmware container file
and installs the new firmware, including the module's configuration files.
4. You are notified when the installation procedure finishes.
5. The module then resets again.
6. The new firmware that has just been loaded starts.

10.3.1.4.5 Resetsetting the Module to the Factory Settings

In many cases, it can be helpful to reset the module to the factory settings. This can be
done for various selectable classes of settings with the Settings menu item on the Fac-
tory reset tab.
Changes to settings require operator or admin rights. If you do not have these, the Set-
tings tab is grayed out and cannot be edited.
Various settings can be reset according to the radio button selection:
Option
Reset Device Informa-
tion
Reset Network Adapter
Settings
Reset Application Pa-
rameters
Reset All
To reset the module to the factory settings, proceed as follows:
68 Product manual | Version: 2.0.0
16DO FLD EI DC 24V 2.0A
Figure 19: Settings Menu Item, Factory Reset Tab (Example View)
Table 42: Options for Resetting the Module to the Factory Settings
Reset Settings
Module settings (e.g., maintenance information, system time settings)
Network adapter settings (communication settings, IP address configuration, sta-
tion name)
Application-specific data (port configuration and parameters, remanent parame-
ters)
All Settings
765-1503/100-000