Appendix; Installation Regulations Specified By Approvals - WAGO 765-1503/100-000 Product Manual

I/o system field. 16-channel digital output; ethernet/ip; 24 v dc; 2.0 a; 8 × m12 connection
Table of Contents

Advertisement

765-1503/100-000

Appendix

Appendix
14

14.1 Installation Regulations Specified by Approvals

Because the following information refers to language-specific regulations, standards or
certifications applicable to the specific installation and operation location, it is presented
in the respective original language.
EU Declaration of Conformity
Hereby, WAGO GmbH & Co. KG declares that the radio equipment type
765-1503/100-000 is in compliance with Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following internet address:
ü www.wago.com
/765-1503/100-000.
FCC/ISED
Legal information:
Radiofrequency radiation exposure Information: This equipment complies with FCC radia-
tion exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance of 20 cm between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
NOTE: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be re-
quired to correct the interference at his own expense.
NOTICE: This device complies with Part 15 of the FCC Rules and contains license-ex-
empt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Devel-
opment Canada's licence-exempt RSS standard(s). Operation is subject to the following
two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may
cause undesired operation.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suiv-
antes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Product manual | Version: 2.0.0
105
16DO FLD EI DC 24V 2.0A

Advertisement

Table of Contents
loading

Table of Contents