Starting Up The Robacta Reamer Twin Parting Agent Nebuliser; Starting Up The Parting Agent Nebuliser - Fronius Robacta Reamer Alu Edition Operating Instructions Manual

Starting up the Robacta Reamer Twin parting
agent nebuliser
Starting up the
NOTE!
parting agent
nebuliser Only use "Robacta Reamer" parting agent (item number 42,0411,8042).
The composition of this parting agent is designed specifically for the cleaning
device. If other manufacturers' products are used, trouble-free operation cannot
be guaranteed.
NOTE!
Use the parting agent - spray unit option to achieve sufficient wetting of the en-
tire Twin welding torch interior.
With the parting agent - spray unit option, the parting agent is sprayed through
the blow out line directly into the welding torch interior.
1
2
3
NOTE!
If the spray amount is not sufficient after starting up the cleaning device, in-
crease it as required:
▶
▶
(1)
Open the sealing plug (1)
Fill with "Robacta Reamer" parting agent using the filling funnel (2)
Close the sealing plug (1)
by adjusting the spray time using the robot control - a spray time of ~ 0.7
seconds is recommended
or by using the parting agent adjuster (4): remove the safety clamp (3), use a
screwdriver to set the parting agent adjuster (4) so that the welding torch in-
terior is coated with a thin layer of parting agent (0.2-0.5 ml) after the spray-
ing action is complete
1
(2) (1)
2 3
(4) (3)
49