Ensuring That The Cleaning Device Is Depressurised - Fronius Robacta Reamer Alu Edition Operating Instructions Manual

Whenever the cleaning device and connected system components are supplied
with voltage and/or compressed air, a risk of serious injury exists from:
▶
▶
▶
▶
▶
▶
If work has to be performed on the cleaning device while it is being supplied with
voltage and/or compressed air:
▶
▶
▶
Ensuring that Attempt to briefly activate the cleaning device without any compressed air sup-
the cleaning ply to check whether the cleaning device is depressurised. Proceed as follows:
device is depres-
1
surised
2
On the Robacta Reamer Alu Edition, Robacta Reamer Alu 3000upm:
3
-
-
On the Robacta Reamer Twin:
3
34
WARNING!
rotating cleaning cutter / rotating cleaning brush
lifting device moving up/down
extending/retracting gas nozzle clamping device
activated wire cutter
flying parts (shavings, etc.)
compressed air/parting agent mixture escaping from the parting-agent injec-
tion nozzles
keep your body, especially your hands, face, hair, any objects and all clothing
away from the cleaning cutter / cleaning brush, lifting device, gas nozzle
clamping device, wire cutter and parting-agent injection nozzles
wear ear protection
wear protective goggles with side protection
Take protective measures:
- The cleaning cutter / cleaning brush, lifting device, gas nozzle clamping
device, wire cutter and parting-agent injection nozzles could start up.
Therefore keep your body, especially your hands, face and hair, any ob-
jects and all clothing away from the parts referred to above
- wear ear protection
- wear protective goggles with side protection
Ensure that the cleaning device has been disconnected from the compressed
air supply
Briefly turn the "Cleaning" screw on the cleaning device 90° to the right, then
turn it straight back to its original position
If the cleaning device does not respond to the turning of the screw, the
cleaning device is depressurised
If the cleaning device responds to the turning of the screw, the cleaning
device is still connected to a compressed air supply.
If this is the case, you must disconnect the cleaning device from the com-
pressed air supply and check again that the cleaning device is depressurised
before starting work
Briefly press the valve lever on the cleaning device wire cutter to the side by
more than 15° using a tool