Robacta Reamer Twin Programme Sequence And Signal Waveform; Cleaning Programme Sequence - Fronius Robacta Reamer Alu Edition Operating Instructions Manual

Robacta Reamer Twin programme sequence and
signal waveform
Cleaning pro-
gramme se-
quence
Risk of damage.
Do not start in automated mode until the cleaning device has been properly in-
stalled and started up.
NOTE!
Not coating the interior of the welding torch may result in permanent soiling of
the torch when welding begins.
Always wet the interior of the welding torch with the manufacturer's parting
agent before starting automatic operation.
Start
Start from position A
- approx. 25 mm (0.98 in.) next to wire cutter
- Speed: high speed mode
Start from position B
- approx. 25 mm (0.98 in.) Enter wire cutter
- Speed: 10 cm/s (236.22 ipm)
- The wire cutter is actuated by the valve
lever of the wire cutter
Wait 0.5 sec.
CAUTION!
Pos. A
Pos. B
63