Adjusting The Gas Nozzle Clamping Device On The Robacta Reamer Alu Edition And Robacta; Adjusting The Gas Nozzle Clamping Device - Fronius Robacta Reamer Alu Edition Operating Instructions Manual

Adjusting the gas nozzle clamping device on the
Robacta Reamer Alu Edition and Robacta Reamer
Alu 3000upm
Adjusting the
NOTE!
gas nozzle
The gas nozzle clamping device must be adjusted so that no bearing pressure is
clamping device
transferred to the robot.
The gas nozzle must only be clamped onto the cylindrical surface.
4
NOTE!
The gas nozzle must be clamped centrally over the cleaning motor.
42
Tighten Allen screws on the guide bolts (1) and (2)
Loosen Allen screws on the guide
1
bolts (1) and (2)
Move the welding torch to the
2
cleaning position
- centrally with respect to the
cleaning motor
Using the adjusting screw (3), posi-
3
tion the clamping device (4) so that
(1)
the clamping device is on the gas
(3)
nozzle
(2)
(4)