Cleaning Program Sequence - Robacta Tc 2000, Robacta Tc 2000 Us; Program Sequence With Parting Agent Nebuliser - Overview; Program Sequence With Parting Agent Nebuliser And Dipping Bowl - Overview; Cooling Welding Torch In The Dipping Bowl - Detailed Description - Fronius Robacta TC 2000 Operating Instructions Manual

Cleaning program sequence - Robacta TC 2000,
Robacta TC 2000 US
Program se- 1.
quence with
2.
parting agent
3.
nebuliser - over-
4.
view
Program se- 1.
quence with 2.
parting agent
3.
nebuliser and
4.
dipping bowl -
5.
overview
Cooling welding Immersing the hot welding torch in the "Robacta TC Cool / Robacta TC Cool MD"
torch in the dip- parting agent has the following benefits:
ping bowl - de- -
tailed descrip- -
tion -
3
4
5
Weld
Clean gas nozzle tip and nozzle fitting
Spray parting agent
Weld
Weld
Cool welding torch in dipping bowl
Clean gas nozzle tip and nozzle fitting
Spray parting agent
Weld
The spatter that has accumulated on the gas nozzle is loosened
The welding torch is cooled down more
The anti-adhesive agent in the "Robacta TC Cool / Robacta TC Cool MD"
parting agent prevents renewed soiling
(1)
max. 75 mm
Depending on the application, hold the welding torch in the dipping bowl for
approximately 1 - 4 seconds so that any air in the torch can escape and the
torch can cool sufficiently
Raise the welding torch back to its original position above the dipping bowl
Allow the welding torch to drip for approximately 1 - 4 seconds or blow down
it with compressed air using the hosepack before bringing it back to its ori-
ginal position for cleaning
After welding, position the welding
1
torch approximately 50 mm (1.97
in.) above the dipping bowl
NOTE!
Do not dip the welding torch more
than 75 mm (2.95 in.) into the dipping
bowl. The gas holes (1) must remain
dry.
(2.95 in.)
Dip the welding torch vertically in-
2
to the dipping bowl
49