Starting Up The Robacta Reamer Twin Parting Agent Nebuliser; Starting Up The Parting Agent Nebuliser - Fronius Robacta Reamer Alu Edition Manual

Starting up the Robacta Reamer Twin parting agent
nebuliser
Starting up the
parting agent
nebuliser
Only use "Robacta Reamer" parting agent (item number 42,0411,8042).
The composition of this parting agent is designed specifically for the cleaning device. If oth-
er manufacturers' products are used, trouble-free operation cannot be guaranteed.
Use the parting agent - spray unit option to achieve sufficient wetting of the entire
Twin welding torch interior.
With the parting agent - spray unit option, the parting agent is sprayed through the blow out
line directly into the welding torch interior.
1
2
3
If the spray amount is not sufficient after starting up the cleaning device, increase it
as required:
► by adjusting the spray time using the robot control - a spray time of ~ 0.7 seconds is
► or by using the parting agent adjuster (4): remove the safety clamp (3), use a screw-
48
NOTE!
NOTE!
Open the sealing plug (1)
Fill with "Robacta Reamer" parting agent using the filling funnel (2)
Close the sealing plug (1)
NOTE!
recommended
driver to set the parting agent adjuster (4) so that the welding torch interior is coated
with a thin layer of parting agent (0.2-0.5 ml) after the spraying action is complete
(1)
1
(2) (1)
2
(4) (3)
3