Control Elements (Supplement) - Leica CM3050 S Service Manual

Chapter 3
Service Manual / Leica CM3050 S
Important note!
The operating instructions below are valid only for
the instrument Leica CM 3050 S. They supplement
chapter 7.5 of the standard Leica CM3050
instruction manual, explaining the new / additional
functions of the Leica CM3050 S unit. All references
to figures, page numbers and / or headings relate to
the instruction manual version 1.3-07/96.
1.
The instrument is no longer switched on/off via the
mains switch shown in Fig. 21.1 (which has been
eliminated in the new Leica CM3050 S) but via
switch (1), which combines the function of ON/OFF
switch and automatic cutout for the instrument.
eingeschaltet. The new layout loos as shown on the
left.
2.
Control panel 1 as shown in Fig. 22.1 will not be
modified as far as shape and key functions are
concerned. New is the instrument name LEICA
CM3050 S, as well as a number of new display
indications.
3.
Module B of control panel 2 shown in Fig. 24.1 has
been changed.
Modules A and C remain the same, i.e. are identical
with those in the Leica CM 3050 unit.
Module B has been modified as follows:
1.
The
button.
To switch on press
The illuminated bar (3) indicates the selected
trimming thickness in µm.
2.
The arrow buttons used in the Leica CM3050 have
been replaced by the
Pressing
display indication), pressing
selected value.
Version 1.0 12/00
© Leica Microsystems

3.18 Control elements (supplement)

Mains switch
Control panel 1
Control panel 2
Trimming
button has been replaced by the
, TRIM (2) illuminates.
Selection keys
and
decreases the selected value (see
buttons.
increases the
Page 70