Anti-Static Precautions; Unpacking Precautions - IEI Technology PM-PV-N4551/D5251 User Manual

2.1 Anti-static Precautions

WARNING:
Failure to take ESD precautions during the installation may result in
permanent damage to the product and severe injury to the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the PM-PV-N4551/D5251. Dry climates are especially susceptible to ESD. It is
therefore critical that whenever the PM-PV-N4551/D5251 or any other electrical
component is handled, the following anti-static precautions are strictly adhered to.

Wear an anti-static wristband: Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.

Self-grounding: Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.

Use an anti-static pad: When configuring the PM-PV-N4551/D5251, place it
on an anti-static pad. This reduces the possibility of ESD damaging the
PM-PV-N4551/D5251.

Only handle the edges of the PCB: When handling the PCB, hold the PCB
by the edges.

2.2 Unpacking Precautions

When the PM-PV-N4551/D5251 is unpacked, please do the following:

Follow the anti-static precautions outlined in Section 2.1.

Make sure the packing box is facing upwards so the PM-PV-N4551/D5251
does not fall out of the box.

Make sure all the components shown in the unpacking section are present.
Page 12
PM-PV-N4551/D5251 User Manual