Table of Contents
Advertisement
IP Subnet Mask: Enter the IP subnet mask.
Default Gateway Address: Enter the IP address of the default gateway or router on the
Ethernet segment connected to the AN-80i Ethernet port.
Flow Control Enable: Check this box
AN-80i Ethernet port. Enabling this feature allows the AN-80i to request Ethernet
devices to pause transmissions during busy periods.
Prioritized Low Latency Mode Enable: Check this box
802.1p tagged traffic. When enabled, this ensures prioritized traffic is transmitted with
the lowest achievable latency, even under conditions of high IP data traffic loading.
SNTP Enable: Check this box
allows AN-80i systems to time-stamp log messages using a network time server. When
enabled, you must enter the network address of the SNTP server in the SNTP Server IP
Address field.
SNTP Server IP Address: Enter the network address of the SNTP server. Valid only
when the SNTP Enable field is checked.
Polling Interval: Enter the SNTP polling interval (hours).
Time Zone (GMT): Enter the hours offset from GMT for this time zone. Valid only when
the SNTP Enable field is checked.
Syslog Enable: Check this box
allows AN-80i log messages to be saved in a central repository. When enabled, you
must enter the network address of the Syslog server in the Syslog Server IP Address
field.
Syslog Server IP Address: Enter the network address of the Syslog server. Valid only
when the Syslog Enable field is checked.
Ethernet Mode: Select the operating mode of the Ethernet port.
Auto - Auto-negotiate the speed connection speed.
10 - Operate at 10Base-T only.
100 - Operate at 100Base-T only.
HD - Operate at half-duplex only.
FD - Operate in full duplex only.
Important: The auto-negotiate feature does not detect the speed and duplex of
manually set Ethernet equipment. The auto-negotiate feature works correctly only
when both communicating Ethernet devices are configured for auto-negotiate. Duplex
mismatches may result in an unexpected loss of communications.
HTTP Enable: Check this box
deselected, only CLI commands will be available.
Telnet Enable: Check this box
to the CLI commands in CLI Interface on page 62.
70-00072-01-06a
Table 3: Web - 802.1p Priority Settings
Priority
Highest
Lowest
Proprietary Redline Communications © 2008
AN-80i
to enable flow control functions (802.3x) on the
0, 3, no tag
to enable the SNTP protocol support. This feature
to enable the Syslog protocol support. This feature
to enable the HTTP (Web) interface. If the option is
to enable a Telnet access (CLI) to the AN-80i. Refer
Page 26 of 96
User
Manual
to enable priority handling of
Setting
6, 7
4, 5
1, 2
June 1, 2008
Advertisement
Table of Contents
