Table of Contents
Advertisement
Step 2: Create Single Pass-through Group
Click New Group to display the Group Configuration screen.
8.
Enter a unique name for this group in the Group Name field.
9.
Set the Group Tagging Mode to Pass-through.
10.
Check the SC Ethernet Enable box
11.
Set the Group QoS value for sending multicasts (i.e., 5). A value of zero (0) disables
12.
all traffic.
Use the default values for all other fields.
13.
Click the Apply button to save and activate these settings.
14.
Step 3: Create Connections
Click New Connection to display the Connection Configuration screen.
1.
Enter a unique name for this connection in the Connection Name field.
2.
Set the Connection Tagging Mode to Pass-through.
3.
Enter the Link ID of a subscriber station in the Link ID field.
4.
Enter the Group ID in the Group ID field.
5.
Set the DL QoS Level and UL QoS Levels. Default values are MAX Burst Rate Value
6.
- 1. A value of zero (0) disables all traffic.
Click the Apply button to save and activate these connection settings.
7.
Repeat steps 1 - 7 to add a connection for each subscriber station.
8.
Step 4: Save Configuration
Click Save in the left-hand menu to permanently save all settings. The system will pass all tagged
and untagged data and management traffic.
The following table provides sample settings for a pass-though group at the sector controller and
connections to two subscriber stations.
Table 12: PMP - Basic Pass-Through Group Configuration Settings
Group Configuration (SC)
Group
Name
Tagging
SC-1
Through
*The group ID and link ID are numbers generated automatically by the AN-80i.
70-00072-01-06a
Group
Group
Connection
VLAN
ID
Mode
Pass
NA
Proprietary Redline Communications © 2008
AN-80i
.
Connection Configuration (SS)
Connection
Name
Tagging
Mode
SS-1
Pass
Through
SS-2
Pass
Through
Page 60 of 96
User
Manual
Link
Group
Connection
VLAN ID
ID
ID
[L-1]*
[SC-1]*
NA
[L-2]*
[SC-1]*
NA
June 1, 2008
Advertisement
Table of Contents
