PTP
PMP
√
√
√
√
√
√
√
√
5.2
Connecting with Telnet
To connect to the AN-80i, open a Telnet session to the IP address of the AN-80i. On a
Windows™ PC, open the Run command and type 'telnet' followed by the IP address of
the AN-80i. When the command prompt screen appears, login to the AN-80i. The AN-80i
may now be controlled using a set of CLI commands.
The system will logout users automatically if no commands are received (idle) for five
minutes. To exit immediately from the CLI, type the following command:
logout [ENTER]
5.3
CLI Command Set
5.3.1
Chgver
Use the chgver command to change the software version to loaded when you reboot
the AN-80i. Also see the Get command 'swver'.
PTP
PMP
√
√
70-00072-01-06a
Table 14: CLI - Root Mode Commands
Command
Description
Tab
When entering a command, hit the Tab key at any time to perform
auto-complete or view available options.
?
Use the '?' character to display help for any command or mode.
Example: From the root directory, enter the following command to
list all parameters that can be changed using the 'set' command:
Return to root mode.
CTRL-Z
Cancel command entry (alternative to backspace delete).
exit
Return to parent node / mode.
all (exit all) Return to root mode.
logout
Terminate this telnet session. May be entered from any mode.
Figure 35: CLI - Connecting via Telnet
Table 15: CLI - chgver
Parameter/Description
Enter this command to toggle between software versions. The setting will
alternate between the two banks of memory (no parameters).
chgver <Enter>
Proprietary Redline Communications © 2008
AN-80i
set ?
Manual
Page 63 of 96
User
June 1, 2008