Table of Contents
Advertisement
Telnet Port: Enter Telnet port address (default is 23).
SNMP Enable: Check this box
(SNMP) agent. When this item is checked, click on the blue text
adjacent to the check box to display the SNMP Configuration screen.
Mgmt. Tag Enable: Check
The Mgmt Tag Enable setting is disabled (factory default) when shipped from the factory
or following a long-reset operation. In this mode the PTP Master and PTP Slave can be
managed through the local Ethernet port using untagged traffic. Over-the-air
management is possible only after creating a pass-through group and pass-through
connections for each PTP Slave.
When Mgmt Tag Enable is enabled, this PTP Master or PTP Slave can be managed
only using VLAN traffic tagged with the value specified in the Mgmt. VID field. Over-the-
air management is possible only after creating a VLAN tagged group and VLAN tagged
connections for each PTP Slave.
It is recommended to create and test a VLAN group for tagged management traffic
before activating the Mgmt Tag Enable function. Set the associated QoS and priority
values to ensure management traffic has adequate priority and bandwidth during system
operation.
Mgmt. VID: Enter the VLAN ID. When Mgmt. Tag Enable is selected, the system
recognizes only management commands with this VLAN ID.
Important: The VLAN network support should be verified before enabling this feature
to ensure the AN-80i system will be reachable using the VLAN tagged traffic.
70-00072-01-06a
this box to enable VLAN tagged traffic.
Proprietary Redline Communications © 2008
AN-80i
to enable the Simple Network Management Protocol
Page 27 of 96
User
Manual
[
]
Configure SNMP
June 1, 2008
Advertisement
Table of Contents
