Table of Contents
Advertisement
PTP
PMP
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
70-00072-01-06a
Parameter/Description
efwtimeout: Enter the period (in seconds) the Ethernet port will remain
disabled following loss of connectivity on the wireless interface. Following this
interval, the Ethernet port will be automatically re-enabled to allow
management of the AN-80i.
encmode: Enable or disable the encryption function.
off - Disable
on - Enable
If encryption is enabled, the correct encryption keys must be entered on both
communicating systems.
enckey: Enter the encryption key. If encryption is enabled, the correct
encryption keys must be entered on both communicating systems. Used only if
encmode is set to 'on'.
<mac>
- <MAC address>
ethmode: Enter the Ethernet speed and duplex setting.
auto - Auto-negotiate
10hd - 10Base-T Half Duplex
10fd - 10Base-T Full Duplex
10hd - 100Base-T Half Duplex
100fd - 100Base-T Full Duplex
exit: Exit from the current mode (go up one level).
flowctrl: Enable or disable the flow control function. The Flow control feature
enables the AN-80i to request other Ethernet devices to pause transmission
during busy periods.
off - Disable
on - Enable
gateway: Enter the IP address of the default gateway on this segment.
gmt: Enter the time offset from GMT (i.e., -5 for EST).
grppri: Group priority.
<id>
- [id number]
<pri>
- <VLAN priority>
grpqos: Group QoS.
<id>
- [id number]
<qos>
- <QoS>
grprate: Group rate.
<id>
- [id number]
<rate>
- <group rate>
grpvid: Group VLAN ID.
<id>
- [id number]
<vid>
- <VLAN ID>
grpviden: Group VLAN enable.
<id>
- [id number]
<mode>
http: Enable or disable the HTTP function. When disabled, the Web interface
will not be available.
off - Disable
on - Enable
Proprietary Redline Communications © 2008
AN-80i
Table 27: CLI - set
- <on/off>
Page 70 of 96
User
Manual
June 1, 2008
Advertisement
Table of Contents
