Configure Pass-Through Operation; Step 1: Create New Link For Each Subscriber; Figure 34: Pmp - Pass-Through Only Deployment - Redline Communications RedCONNEX AN80IB User Manual

The procedures provided below include steps to setup a basic working configuration for
initial testing, and then to introduce VLAN traffic controls.
4.7.1

Configure Pass-Through Operation

For initial installation and testing, it is recommended to setup a PMP configuration
without VLAN support. Use the following steps to configure a PMP pass-through link.

Step 1: Create New Link for Each Subscriber

Click New Link to display the Link Configuration screen.
1.
Enter a unique name for this link in the Link Name field.
2.
Enter the MAC address of the subscriber station in the Peer MAC field.
3.
Enter the UBR for this link (based on link budget calculations).
4.
Use the default values for all other fields.
5.
Click the Apply button to save and activate these settings.
6.
Repeat steps 1 - 6 for each subscriber station.
7.
70-00072-01-06a

Figure 34: PMP - Pass-through Only Deployment

Proprietary Redline Communications © 2008
AN-80i
Page 59 of 96
User
Manual
June 1, 2008