Redline Communications RedCONNEX AN80IB User Manual page 72

PTP PMP
√ √
√ √
√ √
√
√
√ √
√ √
√ √
√
√ √
√ √
√ √
√ √
√ √
70-00072-01-06a
Parameter/Description
rffreq: Enter the center frequency for the RF channel. When operating multiple
links in close proximity, channel frequencies should be separated by a
minimum of the channel size to minimize interference. For example, when
operating in with 20 MHz channels, the separation must be greater than 20
MHz.
snmp: SNMP enable setting.
off - Disable the SNMP agent.
on - Enable the SNMP agent.
snmptraplink: Enable or disable sending an SNMP trap message for each
link-up and link-down event.
<setting> - [on | off]
snmptraps: Status of the SNMP traps flag.
<mode>
snmptraps: Enable or disable sending all SNMP traps.
<setting> - [on | off]
sntp: SNTP enable setting.
off - Disable SNTP protocol support.
on - Enable SNTP protocol support.
sntpip: Enter the SNTP server IP address. Valid only if sntp is enabled.
sntppoll: Enter the interval to synchronize with the sntp server.
<polltime> - SNTP polling interval [hours].
sstoss: Status of packet routing between SSs.
<id> - [id number]
<mode>
syscontact: Enter additional descriptive details about this AN-80i. The
description can be any combination of up to 20 letters and numbers.
sysdescr: Enter descriptive details about this AN-80i. The description can be
any combination of up to 20 letters and numbers.
sysloc: Enter descriptive details about the location of this AN-80i. The
description can be any combination of up to 20 letters and numbers.
syslog: Syslog enable setting.
off - Disable syslog server protocol support.
on - Enable syslog server protocol support.
syslogip: Enter the syslog server IP address. Valid only if syslog is enabled.
Proprietary Redline Communications © 2008
AN-80i
Table 27: CLI - set
- [on | off]
- <on/off> - Route broadcast packets from SS to SS
Page 72 of 96
User
Manual
June 1, 2008