Redline Communications RedCONNEX AN80IB User Manual page 71

PTP PMP
√
√
√ √
√
√ √
√
√
√
√ √
√ √
√
√
√ √
√
√
70-00072-01-06a
Parameter/Description
idname: ID name.
<id> - [id number]
<name>
lkname: Link name.
<name> - <id name> - maximum 15 characters
ipaddr: Enter the IP address and subnet mask of the AN-80i.
Address - IP Address
Mask - Subnet Mask
Yes - Confirmation to proceed
maxdst: Maximum distance to a subscriber [Km].
<distance> - Maximum distance from SC to SS [Km].
maxtxpower: Enter the Tx power level (dBm).
This setting is for the transceiver output only. The actual EIRP depends on the
gain of the connected antenna. See 7.3: Antennas on page 87 for a list the
maximum transmit power setting based on the antenna gain for a series of
frequency settings. The maximum value for this field is determined by the
options key.
mgmtag: Management VLAN enable.
<mode> - [on | off]
mgmvid: Management VLAN ID.
<vlan_id> - <VLAN ID>
mrate: Enter the maximum uncoded burst rate (Mbps). Entry values are
dependant on the channel bandwidth (chwidth).
10 MHz: 3, 4.5, 6, 9, 12, 18, 24 or 27
20 MHz: 6, 12, 18, 24, 30, 36, 48, or 54
40 MHz: 12, 24, 36, 48, 60, 72, 96, or 108
The maximum value for this field is determined by the options key.
netmask: Enter the IP netmask.
optionskey: Enter the options key string.
<kIdx> - Index of the options key [0 | 1]
<kStr> - [<options_key_string>]
peermac: Peer MAC address.
<id> - [id number]
<mac> - <MAC address>
pllm: Enable or disable prioritized low latency mode;
off - Disable
on - Enable
radio: Enable or disable the radio transmitter.
off - Disable
on - Enable
ratedif: Enter the number of modulation levels to step down during re-
transmission of errored wireless packets. The level can be set from 0 to 7
(recommended value = 2).
regper: Frames number between registrations.
<frames> - The number of frames between registrations [4..100].
Proprietary Redline Communications © 2008
AN-80i
Table 27: CLI - set
- <id name> - maximum 15 characters
Page 71 of 96
User
Manual
June 1, 2008