Table of Contents
Advertisement
User
Manual
AN-80i
Auto scan: Check this box
to enable the PTP Slave automatically scan available
channels to locate and register with an AN-80i PTP Master. When the Auto Scan field is
checked, click on the blue text
[
]
adjacent to the check box to display
Frequency Ranges
the Frequency Management screen. Up to 32 frequency ranges may be specified.
Frequency ranges may be entered on the PTP Master and the PTP Slave. Settings
entered on the PTP Master will be downloaded and used by the PTP Slave.
Figure 11: Web - Wireless Configuration Screen
Add Frequency Range
Begin: Enter the lower limit of the frequency scan interval (MHz). The scan interval must
be a subset of the region frequency range. The AN-80i compensates for channel size
when selecting the center frequency.
End: Enter the upper limit of the frequency scan interval (MHz). The scan interval must
be a subset of the region frequency range. The AN-80i compensates for channel size
when selecting the center frequency.
Add: Click to check the range settings and add these to the Local Frequency Range list
(if valid). To save changes to non-volatile memory, return to the Configuration Screen
and click the
button at the bottom of the screen.
Save
Delete Frequency Range
Index: Select the index value for the scan interval delete from the Local Ranges table.
Delete: Click the Delete button to permanently remove the selected scan interval.
Local Frequency Ranges:
These are the (optional) scan intervals for this PTP Slave. The last settings saved in
non-volatile memory will be loaded when the PTP Slave is rebooted.
Remote Frequency Ranges:
When settings are displayed in this table, the frequency scan intervals have been
downloaded from the PTP Master. Setting scan intervals in the PTP Master is optional.
70-00072-01-06a
Page 29 of 96
June 1, 2008
Proprietary Redline Communications © 2008
Advertisement
Table of Contents
