Table 4: Maximum Tx Power Settings (Dbm) - Redline Communications RedCONNEX AN80IB User Manual

Hide thumbs

Table Of Contents

Table of Contents

When present, these settings override the local settings and are used whenever the PTP

Slave has deregistered and is scanning for a PTP Master. This list is not saved

permanently, and is discarded when the PTP Slave is rebooted.

Reload: Display the saved (Local) scan intervals.

Save: If settings are valid, the ranges are added to the Local Frequency Range list. An

event message is logged indicating the results of the test.

Important: Clicking the Save button does not permanently save changes. You must

click Save at the bottom of the

Test: Click to check the range settings and add these to the Local Frequency Range list

(if valid). This action does not save the changes to non-volatile memory.

Operating Notes

If no scan intervals are defined, the PTP Slave will scan all frequency ranges for the

enabled region. If scan intervals are defined, only the listed channels will be scanned for

a PTP Master. If the PTP Slave checks all scan intervals three times without locating

and registering with a PTP Master, the scanning mode is changed to include all

frequency ranges for the enabled region (until registration or reboot).

The PTP Master can also be programmed with a list of scan intervals. When the PTP

Slave registers with a PTP Master that has frequency ranges defined, the list is

transmitted to the PTP Slave and is displayed as Remote Frequency Ranges. When

present, the scan intervals in the Remote Frequency Ranges table are used exclusively

during autoscan (Local Frequency Ranges are ignored). The Remote Frequency

Ranges remain in effect until the PTP Slave is rebooted.

Tx Power [dBm]: Enter the transmit power level (dBm). This setting is for the

transceiver output only. The actual EIRP depends on the gain of the connected antenna.

Refer to the following tables to determine the maximum transmit power level available at

each modulation setting. When ATPC is enabled, the Tx power is automatically adjusted

to achieve optimum performance. When DFS is enabled, the subscriber Tx power may

be automatically adjusted (regardless of ATPC setting) to avoid false DFS triggering.

Radio

App.

T49

PTP

PMP

T54 / T58 PTP

PMP

70-00072-01-06a

System Configuration