Clear; Del; Enable; Freq - Redline Communications RedCONNEX AN80IB User Manual

5.3.2

Clear

Use the clear command to delete all IDs from an ID table.
PTP PMP
√
5.3.3

Del

Use the del command to delete a specific ID.
PTP PMP
√
5.3.4

Enable

Use the enable command to re-enable a specific ID (that was disabled).
PTP PMP
√
5.3.5

Freq

Use the freq command to configure frequency ranges when using autoscan or DFS.
PTP PMP
√
70-00072-01-06a

Table 16: CLI - clear

Parameter/Description
clear
idtable - Clear all the IDs
Parameter/Description
del
<id> - [id number]

Table 18: CLI - enable

Parameter/Description
enable
<id> - [id number]

Table 19: CLI - enable

Parameter/Description
freq
add Add a frequency range (up to 32 ranges).
<begin>
<end>
del Delete a frequency validation range
<index>
print Print the list of frequency validation ranges.
Local frequency ranges:
<index> <begin> <end>
reload Reload the active list of frequency validation ranges.
Proprietary Redline Communications © 2008
AN-80i

Table 17: CLI - del

- start frequency (MHz)
- end frequency (MHz)
- Frequency validation range index
Page 64 of 96
User
Manual
June 1, 2008