Table of Contents
Advertisement
3.2.3 Action Menu
Start Session: Start a session with an RDL-2000 (CTRL-S). Choose an RDL-2000 unit
discovered by the Link Manager, enter the required credentials, and click Login to begin
a session.
The Start Session function scans the entire subnet on the local network to identify RDL-
2000 units. It is not required to specify the IP address.
Figure 7: Link Mgr - Select Ethernet Adapter and Default Gateway
Unit List
Unit Type: Identifies unit, Master/Slave configuration, and region setting.
MAC Address: MAC address of detected unit.
IP Address: IP address of detected unit.
Controls
Login: Login to the selected RDL-2000 using the current login settings (below).
Discover Sus: Query a Master to discover the remote Slave.
Cancel: Close this dialog.
Login Settings
User: Select the user account type.
Admin: Authority to change configuration.
User: Allowed only to view configuration and monitor operation.
Password: Enter password for the selected user type.
Remember Settings: Check this box
End Session: Terminate the current RDL-2000 session (CTRL-E).
Refresh Unit Parameters: Retrieve settings from the connected RDL-2000 (CTLR-U).
Get Reset Text: Retrieve the recorded cause of the last reset for the connected RDL-
2000 and display this text in the log window (CTRL-T). Refer to Table 6: Maintenance -
Causes of System
previous reboot.
70-00143-01-01a
RDL-2000
to always use these login parameters.
on page 40. This includes the total uptime (seconds) from the
Proprietary Redline Communications © 2010
User Manual
Page 17 of 50 September 20, 2010
Advertisement
Table of Contents
