5.3.16 Snmptrap
Use the snmptrap command to configure the SNMP trap message reporting.
PTP
PMP
√
√
5.3.17 Test
Use the test command to load the current edited (but not permanently saved)
configuration settings.
PTP
PMP
√
√
The AN-80i will operate with these settings for a period of five minutes. During the 'test'
period, you may click the Save button at any time to save this configuration permanently
(also terminating the five minute timer). If the Save button is not selected, the previous
saved settings are reloaded.
5.3.18 Upgrade
Use the upgrade command to upload a new software binary file to the AN-80i.
PTP
PMP
√
√
70-00072-01-06a
Table 30: CLI - snmptrap
Description
add: add a new snmp trap to the snmp trap table. The index value is assigned
automatically. Up to eight settings can be entered.
snmptrap add <ipaddr> <port> <community> <Enter>
change: Modify the specified snmp setting.
snmptrap change <idx> [-p <port>] [-i <ip_add>] [-c <community] <Ent>
del: Delete the specified snmp setting.
snmptrap del <idx> <Enter>
print: List all SNMP trap settings.
snmptrap print <Enter>
Parameter/Description
config - AN-80i configuration settings
test config <Enter>
Table 32: CLI - upgrade
Description
ipaddr: Enter the IP address of the TFTP server.
filename: Enter the name of the binary file to be uploaded to the AN-80i.
upgrade <ipaddr> <filename> <Enter>
You must specify the TFTP server address and the full name of the binary file
(including .bin extension). The AN-80i software binary file must be located in
the default directory of the TFTP server.
Proprietary Redline Communications © 2008
AN-80i
Table 31: CLI - test
Manual
Page 77 of 96
User
June 1, 2008