Table 5: Web - Ethernet Status Indication - Redline Communications RedCONNEX AN80IB User Manual

Hide thumbs

Table Of Contents

Table of Contents

Adaptive Modulation: Check this box

the transmission modulation and code settings to achieve the highest UBR that will

operate with a packet error rate (PER at layer 2) of less than 1x10e-6. If the PER

exceeds 1x10e-6, the AN-80i automatically adjusts the modulation and code settings

downwards (i.e., from 16 QAM 3/4 to 16 QAM 1/2) to operate at a lower UBR where the

PER is acceptable. When disabled, the modulation and code settings are entered

manually using the Uncoded Burst Rate setting. See Table 4: Maximum TX Power

Settings (dBm).

Modulation Reduction Level: Enter the number of modulation/coding levels to step

down during re-transmission of errored wireless packets. Each step down lowers the

UBR. The level can be set from 0 to 7 (recommended value = 2).

Uncoded Burst Rate [Mb/s]: Select the desired UBR for the link. If Adaptive Modulation

is disabled, the AN-80i will transmit using only the specified settings. See Table 4:

Maximum TX Power Settings (dBm).

Channel Width [MHz]: Select the channel bandwidth. Refer to Table 51: Spec. -

Regional Identification Codes on page 92 for available channel widths.

Ethernet Follows Wireless: Check this box

the Ethernet port function based on the status of the wireless interface. This feature

allows switches and routers to trigger configuration changes based on changes to the

AN-80i Ethernet port status.

Disabled ( ): The AN-80i Ethernet port is always enabled.

Enabled ( ):Ethernet port is controlled based on the status of the wireless interface.

Important: The

traffic (HTTP, TELNET, and SNMP). While activated, it is not possible to manage the

AN-80i using the Ethernet port.

Ethernet follows wireless timeout [sec]: Enter the period (in seconds) the Ethernet

port will remain disabled following loss of connectivity on the wireless interface.

Following this interval, the Ethernet port will be automatically re-enabled to allow

management of the AN-80i.

Important:

switches/routers monitoring the Ethernet port must be programmed to not switch

automatically when the Ethernet port function is restored -- the wireless interface may

not be operational.

System Mode: Set the operating mode for each AN-80i system.

PTP Master: This unit begins transmitting automatically; sends poll messages to the

remote AN-80i, and negotiates the wireless link.

PTP Slave: This unit waits passively, monitoring the selected channel(s) until polled

by the PTP Master, and participates in negotiating the wireless link.

Software Version: Select the version of system software to load when the AN-80i is

rebooted. The system holds two independent software images.

70-00072-01-06a