Redline Communications RedCONNEX AN80IB User Manual page 73

PTP PMP
√ √
√ √
√ √
√ √
√
√
70-00072-01-06a
Parameter/Description
sysmode:
PTP Operation:
ptpsector controller - The sector controller (base station) begins
transmitting automatically; sending poll messages to locate the
remote subscribers (ptpsubscriber).
ptpsubscriber - Subscriber waits passively, monitoring the selected
channel(s) until polled by the ptpsector controller (base station).
PMP Operation:
pmpsc - The sector controller (base station) begins transmitting
automatically; sending poll messages to locate the remote
subscribers (pmpss).
pmpss - Subscribers wait passively, monitoring the selected channel(s)
until polled by the pmpsc (sector controller).
<SysMode>
sysname: Enter the name for this AN-80i. The name can be any combination
of up to 20 letters and numbers.
telnet: Enable or disable the Telnet port. If the Telnet port is disabled, it will not
be possible to use the CLI interface.
off - Disable
on - Enable
Changes to this field are effective only following reboot.
telnetport: Enter Telnet port address (default is 23).
ulqos: Uplink QoS.
<id> - [id number]
<qos> - <QoS>
ulrate: Set the uplink rate.
<id> - [id number]
<rate> - <rate>
Proprietary Redline Communications © 2008
AN-80i
Table 27: CLI - set
- [pmpss | pmpsc]
Page 73 of 96
User
Manual
June 1, 2008