Performing A Test - Ametek Davenport PET Plus User Manual

16.6 PERFORMING A TEST

Click on the OPEN AN EXISTING BATCH button
on the Welcome screen.
Note that if the Welcome screen is not displayed,
it can be displayed by clicking on the 9th Icon
from the left on the toolbar.
An OPEN dialog will be displayed as shown.
Select the required test file then click on the
OPEN button.
Note that the above steps do not have to be
performed if the test is run immediately after the
test file has been defined as shown in the
previous section.
The graph screen will be displayed as shown.
Click on the green START TEST button at the
left hand side of the graph to start the test.
If any pre-test questions have been defined, a
dialog will be displayed requesting the answers.
96 PET Plus User Manual