Table of Contents
Advertisement
7.0 PERFORMING A TEST
7.1 SELECTING THE REQUIRED TEST SETUP
Display the "Select Test" screen to select one of the pre-defined test set-ups.
Note that the third line alternates between the Date and Time display and the Barrel Temperature.
Also note that the barrel heaters are not switched on until either the key under SELECT is pressed or
the PC software is started.
The heaters are then active and the barrel will heat and maintain the required test temperature until
the equipment is switched off.
The required test temperature is specified either in the test set-up as shown earlier or in the PC Test
set-up.
Press the key under > or < to select the test set-up that is to be used for the sample testing.
When the required test set-up is displayed, press the key under SELECT to display the "Analysis"
screen.
40 PET Plus User Manual
Advertisement
Table of Contents
