Creating A Test Setup; Default Test Setups - Ametek Davenport PET Plus User Manual

5.0 CREATING A TEST SETUP

5.1 DEFAULT TEST SETUPS

The equipment is supplied with 4 pre-defined test set-ups called:
284_20THOU
n
295_20THOU
n
295_30THOU
n
TRAINING
n
The first test set-up is preset to give a barrel temperature of 284ºC but the other 3 are preset to give a
barrel temperature of 295ºC.
The 295_30THOU test set-up is preset for a 30 thou die (0.0762cm) but the other 3 are preset for a
20 thou die (0.0508cm).
The test set-up called TRAINING sets the equipment into a special training mode and does NOT
perform a melt test.
Note that the special training mode is only available if the test set-up is called TRAINING.
Each test set-up contains separate results storage so that the statistics for each type of test can be
easily viewed, so a different test set-up should be used for:
A different polymer
n
A different production drier or extruder
n
Therefore, a different test set-up should be used to store the test data for (say):
Incoming resin
n
Production Drier number 1
n
Production Drier number 2 (etc)
n
PET Plus User Manual 33