Table of Contents
Advertisement
Section 2 – Operating Instructions
The chart recorder is configured at the factory and will be ready for use at power-up. A
manual has been enclosed for your reference.
The Bearden unit indicator is pre-configured at the factory to alarm at 100 Bc. The alarms
control four items. First, an audible alarm is triggered; second, the heater current is cut off;
third, the motor is shut off; and fourth, the timer is stopped.
Preparing the Instrument for a Test
Prior to running a test, the following steps must be performed.
Configuring the Consistency Display
1. Turn on the instrument.
2. Press
3. Use
A manual has been enclosed for your reference.
Programming the Temperature and Pressure Controllers
The programming for the temperature and pressure controllers is identical. The following is
a brief procedure for programming the controllers. For complete instructions, see the Model
9050, 9051, 9060, 9061, 9080 Controller Manual (9050-1050).
Up to 10 Programs can be stored in the device. Press
or Down) to select the Program Number. The 5270 DACS software utilizes Program 1 when
a profile is downloaded to the controller for an automated test.
1. Press the Page Key
select Program Number 1.
2. Press the Scroll Key
3. Press the Scroll Key
select the segment type.
4. Press the Scroll Key
or TimeToTarget). Press the Up
5. Press the Page Key
6. Press the Page Key
7. Press the Page Key
8. Press the Page Key
9. From any point press Page
10. To manually start or stop a program, press the F1 key to toggle Automatic and Manual
Mode (the Hand icon
Program.
(Scroll) twice (BC THRESHOLD is displayed).
or
(Up or Down) to change the alarm limit.
several times until P.Set is displayed. Press Up
several times until S.NUM 1 (Segment Number 1) is displayed.
(S.TYPE is displayed). Press the Up
to advance through the Segment Type settings (Target Setpoint
at any time to return to the Segment Number prompt.
again to return to the Program Number prompt.
again to return to the Program Setup List.
again to return to the Home Display.
indicates Manual Mode). Press the F2 key to Run or Reset the
SECTION 2 – OPERATING INSTRUCTIONS
or Down
keys to change the Segment settings.
and Scroll
to return to the Home Display.
(Page) and then (Scroll); use or (Up
or Down
or Down
2-1
to
keys to
Advertisement
Table of Contents
