Frequently Asked Questions; Service; Troubleshooting - Energetics E-102 User Manual

User Manual

Frequently asked questions

How are the computer settings reset?
1. Reset: .Hold .the .RESET-key .for .a .minimum .of .2 .seconds .and .all .functions .
will .be .reset . . Information .not .saved .will .be .lost .
2. Power supply: .If .removing .the .batteries .from .the .back .of .the .computer .
disconnects .the .power .supply, .all .functions .are .reset .and .information .not .
saved .it .lost .
Can the workout/program be interrupted?
The .training .is .interrupted .when .the .computer .no .longer .receives .a .signal .
from .the .unit, .the .values .will .no .longer .be .recorded . . Y ou .can .resume .training .
and .the .values .continue .counting . .
!
If the training is interrupted for more than 4 minutes the compu-
ter stops and all values recorded so far are lost.
Heart rate monitoring – can chest strap and hand pulse sensors be
used at the same time?
The .E-102 .has .no .receiver .for .a .chest .strap .signal .

Service

Troubleshooting

Computer display is not working
• . T he .computer .might .not .be .getting .power . . Check .if .the .batteries .are .
inserted .properly .
• . T he .batteries .might .need .to .be .replaced .
• .Contact .your .local .ENERGETICS-dealer .if .you .have .checked .all .connections .
and .the .display .is .still .not .working .
The computer does not show values during the workout
• .Check .if .the .data .cable .is .connected .properly .
Heart rate (PULSE) shows no or incorrect read out
• .Check .if .your .palms .have .proper .contact .with .the .sensors . . Both .palms .have .
to .be .in .contact .with .the .sensors .simultaneously . . T he .display .may .be .on .a .
slight .delay .
• .Check .all .cable .connections .
• . T ry .moistening .your .hands .if .they .are .dry .
The computer has shut down
In .rare .cases .the .computer .might .shut .down, .mainly .because .of .sudden .
changes .in .the .electrical .current .or .static .discharge . . Normally .the .E-102 .
restarts .on .its .own .
If .this .should .not .occur .a .restart .can .be .performed .by .removing .the .batteries .
for .a .moment .and .reinserting .them .